Testimonial by: Joe Ruggiero of Philadelphia, PA
Date added: 11/04/2011
Title: Computer circuit board pen kit
This is a great looking pen when finished but beware! It chips very easily. I found that i was unable to do more than just "round" this blank up and then needed to use a lot
(1 full sheet cut into 1 inch strips) of 150 grit paper to take it down to its proper size. Once that was done, i used 240/320/400 all dry and started wet sanding with 240 down to about 1000. I finised with two coats of One Step. I'm not sure I'd do another but i must admit that it is a great looking pen and a real conversation starter.
Click to view all testimonials
|
|
|
Amalgam-Mutt Large Blanks
