Price is for 1 4-pack of 3/8 inch 10 inch white enamel tubes.
For use with the following kits if cut to the proper length:
- 30 Caliber Bolt Action Rifle
- Steampunk Bolt Action Rifle
To cut the brass tubes you can cut them with a very fine hacksaw blade, a tube cutter, or with a Dremel and cutting disk. However you cut them, it will leave a rough/sharp edge on the end you cut. A rat tail file can be used to smooth the interior of the tube and the exterior can be cleaned up with some sandpaper. Or better yet, use an end mill to trim the end to length. That will trim it flush and can be done at the same time as squaring the ends of the blank. If you can cast or glue the tube into the turning material that will give the tube extra strength to prevent deformation when you cut it.
Attention International Customers - Due to the length of this product, it will require a medium flat rate box to ship. Adding multiple pieces to your cart will likely cause the shipping to be higher than it really is. Please contact us before purchasing.