Click photo to enlarge.

Price is per blank. The blanks shown are representative of the blank you will receive, but are not necessarily the exact blank you will receive.

Dimensions: 3/4"+ x 5"+.
Material: Alumilite
Base Color(s): Green, Brown, Interference Green
Glitter(s): Chunky Green Holographic Mix, Green Ultra Fine Holographic
Transparency: Medium-High
Notes:
- Shown finished on Cigar tubes. The interior of the blank was painted gold after drilling.
- Some of the glitter is cast in clear resin so there may be bare spots that will show through if used on a tubed kit. While we recommend that you consider painting the interior of all the glitter blanks after drilling, we highly recommend it for this blank. Please note that you likely will have bare spots on a thin walled kit and even thicker walled kits.

Bear Tooth Woods is bringing you a group of limited-edition Halloween 2021 inspired blanks that will only be available September 27th - October 31st, 2021. Any blanks on the shelf after October 31st will still be available for sale, but no additional blanks will be made after that time.

Living Dead is a mixture of mottled greens and browns with a splash of chunky green holographic glitter to give your project that decrepit zombie look without having to worry about having your brains eaten.

Our Glitter Alumilite blanks have that butter-smooth turn that you've come to expect from Alumilite, however the glitter does tend to make a mess. Expect to find glitter for a while after you turn. When finishing the glitter blank, we've found that using a CA finish has given us the smoothest finish. If you don’t use a CA Finish (we use a few coats of Ultra Thin), you might be able to feel the slightest texture of the glitter on the surface of your turned blank.

Small voids in any Glitter blanks are to be expected. We put a lot of glitter in these blanks and some air bubbles and small tear-outs will occur when turning. We recommend using medium viscosity CA glue to fill these voids while the lathe is turned off. Be absolutely sure the CA glue has FULLY cured before you turn the lathe back on.

These Glitter Alumilite blanks are made in-house here at Bear Tooth Woods. Please feel free to email us with any comments, concerns, suggestions, etc about the glitter blanks.